Smart-technologies ID422w Manuel d'utilisateur télécharger pdf (Page 46)

36 | CHAPTER 4 – MAINTAINING THE INTERACTIVE PEN DISPLAY

Cleaning the Unit Casing and the Pen

To clean the unit casing

and the pen

Use only a damp cloth or a cloth dampened with very mild detergent to clean the unit

casing and tethered pen.

CAUTIONS

• Do not apply paint thinner, benzene, alcohol or other solvents to the casing.

If you use these cleaners, you may damage the finish. Using such cleaners

also voids the warranty.

• The tethered pen is a sealed unit that contains electronics but no batteries.

If you attempt to open the tethered pen, you will damage these electronics.

This will make the tethered pen unusable and void the warranty.

• Do not immerse the pen in liquid.

• Do not use a pen if the nib has worn down to a sharp or angular tip, as it may

damage the screen. Replace the nib when you notice it becoming short

or angular.

Replacing the Pen Nib

Your interactive pen display comes with five replacement pen nibs and an o-ring tool

to assist in nib replacement. If you require more replacement nibs, contact your

authorised SMART reseller

NOTE

If you misplace your o-ring tool, use a pair of tweezers or pliers to remove the nib.

To replace the pen nib 1. Using the o-ring tool, grab the pen nib and slide it straight out of the pen.

2. Insert a new nib straight into the barrel of the pen. Push the nib firmly until it stops.

3. a

O-Ring Tool

Stylus Tip

Pen Nib

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 65 66

Pas de commentaire

Smart-technologies ID422w Manuel d'utilisateur Page 46